10
2
Connect the appliance to the power
supply, press the lever right down to the
bottom and place a collecting container
under the spout. The device automatically
switches over to off/standby mode.
3
If you press any of the buttons the
appliance will switch on and heat up.
All button symbols blink (see figure 3b).
After heating up, only the milk button
which has been used for rinsing is illumi-
nated.
1
Remove the water tank, fill it up with
fresh drinking water and reinsert it in the
appliance.
SAFETY INFORMATION
Before initial start-up, it is
imperative that you read the
safety information on pages 5-7.
NOTE
1. If the appliance has been
subjected to very cold tem-
peratures or frost, please wait at least
three hours before switching it on. Al-
low the appliance to warm up to room
temperature first - malfunction hazard.
2. We recommend the use of a water
filter for long and optimum coffee en-
joyment. Please insert this only after
the initial start-up. Please read the
instructions on pages 12/13 for this
purpose.
WARNING
Before initial start-up, please
ensure that the mains voltage
complies with that stated on the
nameplate (underside of appliance).
1
On
3a
2
Initial start-up