18
Install the horizontal stabilizers at this time. Install the carbon fiber stabilizer tube. Slide in each half
and secure them with four 6/32 retention bolts.
Lets install the wings at this time and check our center of gravity (CG). Install the carbon fiber wing
tube. Slide in each wing panel and secure them with the four nylon wing retention bolts.
Tip#8 If the wing is tight you can coat the tube with a little baby powder to aid the insertion of the wing
panels.
Tip#9 For added protection in case the wing retention bolts back out during flight; you can add hitch pins to
the anti-rotation pins of the wing. With the wings installed, mark the anti-rotation pins ¼ inch from the
fuselage side. Remove the wings and drill a small hole in the anti-rotation pins. You can find appropriate
sized hitch pins at most local hardware stores. Re-install wings and insert the hitch pins for added
protection.
Now we’re ready to check the CG and install your remaining hardware. The CG range is 7-1/2 to 9” inches
back as measured where the wing meets the fuselage or center of wing tube. We recommend 8 inches for initial
flights.
Check CG at this time and place your batteries and remaining hardware in locations to attain the desired
CG. If satisfied mount your remaining hardware.
Congratulations! You have just completed assembly of your Edge540 and or 540T. Now would be a good time
to install the optional vinyl graphics included with your kit.