14
Chapter 8
Hardware Installation
We provide high quality aluminum control horn assemblies included with our latest generation of PAU aircraft
kits. We believe these lightweight assemblies are the best available and can also be purchased separately from
PAU.
Place an “
×
×
×
×
” to ensure task completion:
What you will need in this chapter:
The entire airframe
Ten H9 titanium push rods
Ten sets of aluminum control horn assemblies
Ten steel posts, 80mm. You will have extras
that are too short. Use the long ones for
ailerons.
12 HD Dubro ball links
One 50oz Du-bro fuel tank
Pull-Pull system
Not Provided:
Six 200oz or better servos for ailerons
Four 200oz or better servos for elevators
Two or three servos for rudder equaling 800oz
One throttle servo 70oz or better
Ten 1.5” aluminum servo arms
One or two 3” arms to tie rudder servos
One 4” offset rudder servo arm
One Fuel dot or other fueling device
Some foam rubber for mounting receiver, ignition module, and fuel tank
Install all your flight control servos with the output shaft closest to the control surface.
Install 6 200oz or better servos for the ailerons in the servo trays located in the bottom of the wings. Use
very high quality servos! These surfaces are huge and carry big loads!
Install 4 200oz or better servos for the elevators in the servo trays located in the bottom of the horizontal
stabilizers.
Install two or three equaling 800oz or better servos for the rudder in the servo tray inside the fuselage.
Install your throttle and or choke servos in the forward bays provided.