17
fitting in the carburetor line that connects to your fuel dot or fueling device. Make sure you use Tygon
fuel tubing inside the tank for the clunk as well.
Install the fuel tank just in front of the wing tube using zip-ties or hook and latch (Velcro) straps. Place
a loop in the vent line over the top of the tank to prevent fuel loss during flight and improve flight times.
Take small zip-ties or fuel line clamps and fasten to all the points where the fuels lines connect.
There are two switch locations already cut on each side of the fuse. They will both accept HD standard
switches. Mount your switches at this time.
Install the fuel-filling device in a location of your choice. In this case, we installed it just behind the
ignition switch.
Install your throttle push rod. Again as mentioned earlier, we do not want metal-to-metal contact at the
attachment point on the engine. Use a 4/40-rod with a 2/56 ball link for 4/40 rod to attach the push rod
to the motor.
Once satisfied with your throttle setup, mount the cowl using the six 6/32 bolts provided and attach the
prop and spinner.
Install the horizontal stabilizers at this time. Install the carbon fiber stabilizer tube. Slide in each half
and secure them with the four 4/40 retention bolts.