11
*To Re-Assemble the Machine reverse the above procedure. Hopper bolts should only be hand
tightened with the speed driver provided.
*The Knock Out Cup Should be installed on the Machine after all other parts are in place but
before the guards are installed. The Mold Plate should be all the way forward and the Knock Out
Arm should be in the down position for the cup to align with the Mold Plate properly.
Patty-O-Matic Inc. offers the highest quality patty paper, machine lubricant, and
machine grease. Please contact the factory for information on these products.
Toll Free in the U.S.A. 877-938-5244
www.pattyomatic.com [email protected]
Paper Sleeves Stops should be
adjusted for different size patty paper
- Remove the Knock Out Cup by loosening
the Knock Out Knob while holding the other
end of the bolt with the Speed Driver
provided with the machine.
- All of the parts that were removed from the
machine can now be washed and sanitized
thoroughly. USDA recommends the
sanitizing solution should be 50 parts per
million but no more than 200 parts per
million. The machine itself should be
cleaned and sanitized by hand. After all
the parts are cleaned, sanitized and dry
they should be coated in mineral oil as an
extra protectant.
DO NOT HOSE DOWN OR PRESSURE
WASH THIS MACHINE!
Knock Out Cup
Installing Patty Paper on
Interleaver
-Place a stack of paper no thicker
than 3/4 inch under the pressure
foot. Slide the hole in the paper
over the center pin.
*Placing more than 3/4 inch of
paper may cause improper paper
feeding.
Shown without guard for better visual
Knock Out
Knob
Speed Driver
Center Pin
Pressure Foot
Paper Sleeve Stops
