10
- Remove Feed Tray by lifting it off the
Hopper, and the Rear Machine Guard by
loosening the Guard Bolts, and unlatching
the push rod.
- Remove the four Hopper Bolts using the
provided speed driver. Loosen the two
bolts on the Chamber Lid so it can be
removed for additional cleaning.
- Remove Pressure Plate by detaching
spring and sliding Pressure Plate from the
inside of the hopper. Remove Feeder Bolt
by unscrewing it hold down bolt with the
speed driver, and removing feeder washer
from the machine. Spin the Feeder until it
clears the meat stop and lift it from the
inside of the Hopper.
- After the Hopper is removed from the
machine remove the Transition Plate from
the top of the Guide Rails. Occasionally the
Transition Plate may stick to the bottom of
the Hopper
- Remove the Mold Plate by pulling the ring
pin and disengaging the Connecting Arm
from the T-Knob. This will allow the Mold
Plate to be removed from between the Guide
Rails and removed from the machine. The T-
Knob may also be un-screwed from the Back
Drive as an alternate means of disassembly.
Proper Disassembly for Cleaning
your Model PR12
Always Unplug Machine from its
Electrical Source Before Cleaning
- Remove the Hopper by lifting it off the
Main Shaft of the machine.
10
Chamber Lid
Hopper
Hopper Bolts
Hopper
Main Shaft
Mold Plate
Back Drive
T-Knob
Transition Plate
Connecting Arm
Ring Pin
Push Rod
Pressure Plate
Guard Bolts
Rear Machine Guard
Feeder
Feed Tray
