Configure the IP address
34
SmartNode 2290 Series User Manual
4 • Getting started with the SmartNode
Login
1.
Accessing your SmartNode via the local console port (or via a Telnet session) causes the login screen to dis-
play. Type the factory default login:
administrator
and leave the password empty. Press the
Enter
key after
the password prompt.
login:administrator
password: <Enter>
172.16.40.1>
2.
After you have successfully logged in you are in the operator execution mode, indicated by > as command
line prompt. With the commands
enable
and
configure
you enter the configuration mode.
172.16.40.1>enable
172.16.40.1#configure
172.16.40.1(cfg)#
3.
Enter the following commands for the first SmartNode 229x device in the pair:
Copy nvram:a-side-config startup-config
Copy running-config startup-config
4.
Follow the same procedure for the other SmartNode 229x device in the pair:
Copy nvram:b-side-config startup-config
Copy running-config startup-config
Note
The configuration above is only a sample configuration that you may use as
an example. You should specify your own parameters such as your IP address
and other related parameters as required. For detailed information about
configuring and operating guidance, set up procedures, and troubleshooting,
refer to the
SmartNode Series SmartWare Software Configuration Guide
avail-
able online at
www.patton.com/manuals
.
5.
Reboot both units and connect them back-to-back through their Ethernet 0/1 ports. Voice connections
will automatically be set up between the units.
The steps above will configure the IP addresses as well as the required configurations for voice connections.
