Patton electronics RocketLink-G 3088/I, Getting Started Manual, Page: 51 / 61

Management 51
3088/I Getting Started Guide B • Specifications
Management
• Web-based configuration via embedded web server
• CLI menu for configuration, management, and diagnostics
• Local (VT-100 or Telnet)
• Console port set at 9600 bps, 8 bits, no parity, 1 stop bit, no flow control
10Base-T/100Base-TX interface
The Ethernet port is a shielded RJ-45 jack, autonegotiate, full- or half-duplex with an MDI-X switch. See
Appendix E,
“RJ-45 shielded 10/100 Ethernet port” on page 58 for the pinout.
Serial connector
The console port is an RS-232 interface (EIA-561) on an RJ-45 jack. See Appendix F, “RS-232 console inter-
face pin assignments” on page 60 for the pinout.
Diagnostics
Various diagnostic features are integrated into the 3088/I NTU. Ping and Traceroute facilities. DSL run-time
statistics, DSL line error counters, Local interface error counters, Bridged PPP statistics, Ethernet port statis-
tics, and front panel status LEDs (see section
“Status LEDs” .)
Status LEDs
Power
The Power LED glows solid during normal operation. At startup, during the POST, the LED blinks once
every second. If the POST fails, the unit does not enter normal operation, and the LED blinks once every
0.4 seconds.
WAN Link
The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once
every second.
WAN Tx
The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once
every second.
WAN Rx
The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once
every second.
Ethernet Link
The DSL LED glows solid while a DSL link is established. While the DSL link is training it blinks once
every second.