Configure the IP address
20
3088/I Getting Started Guide
2 • Initial Configuration
Connect the G.SHDSL port
3.
Obtain single-twisted-pair cable with an RJ-11 plug connector at each end.
4.
Plug one end of the cable into the (yellow) RJ-11 socket (labelled
Line)
on the G.SHDSL NTU.
(See
figure 6
.)
5.
Plug the other end of the cable into the RJ-11 wall socket that provides your G.SHDSL service.
6.
Go to
G.SHDSL > Configuration
to configure the DSL port parameters.
Note
If two G.SHDSL NTUs are connected back-to-back, one must be config-
ured as
Remote
, the other as
Central
.
7.
The
WAN Link
LED will flash while in the process of establishing a link. The LED will be on constantly
once a valid DSL connection is established.
Figure 6. Rear view of LB510A showing DSL RJ-11 jack
MDI-X
Line
Ethernet
Power
Console
Summary of Contents for RocketLink-G 3088/I
Page 7: ...7 3088 I Getting Started Guide Table of Contents RS 232 console interface pin assignments 61...
Page 9: ...9 List of Tables 1 General conventions 13...
Page 14: ...14 Chapter 1 General information Chapter contents RocketLink G 3088 I overview 15 Features 15...
Page 56: ...56 Appendix D RJ 11 non shielded DSL port Chapter contents RJ 11 non shielded DSL port 57...
