IP configuration
30
3088/I Getting Started Guide
4 • Ethernet & WAN PPP config and status
IP configuration
The most commonly used technique for changing the IP address and subnet mask is in the initial configura-
tion via the console port. However you can also change the IP address in the web GUI pages. In the Configu-
ration web pages is located the section for changing these two parameters. Enter the IP address and subnet
mask to be used and click on the
Update
button.
After this change, you must change the IP address in your browser to login and view the web pages again. Be
sure to save the changes into non-volatile memory. (See
“Saving the configuration”
on page 35.)
Figure 14. Configuration of the IP address and subnet mask
PPP configuration
Also found in the Configuration web pages is the parameter for enabling or disabling the Bridged PPP connec-
tion. Simply select
true
for enabling the PPP link and click on the
Configure
button.
Figure 15. Enabling Bridged PPP over the DSL link
Ethernet port configuration
The Ethernet port rarely needs to be reconfigured. However a wealth of Ethernet statistics are available when
analyzing network performance.
Ethernet Basic Port Attributes
Click on the Ethernet hyperlink to see the basic Ethernet statistical parameters. Important statistics include the
link speed, full- or half-duplex operation, the MAC address, collisions and errors. This is primarily a
diagnostic tool.
Summary of Contents for RocketLink-G 3088/I
Page 7: ...7 3088 I Getting Started Guide Table of Contents RS 232 console interface pin assignments 61...
Page 9: ...9 List of Tables 1 General conventions 13...
Page 14: ...14 Chapter 1 General information Chapter contents RocketLink G 3088 I overview 15 Features 15...
Page 56: ...56 Appendix D RJ 11 non shielded DSL port Chapter contents RJ 11 non shielded DSL port 57...
