Creating and modifying global configuration templates
162
Model 1001MC Operations Guide
7 • Model 2701RC management
•
Tx Clock Timing, this selects the source of the DTE Transmit Clock signal. Note that Clock Mode above
is for the transmitted E1 signal.
-
external(0)—Use only when the Clock Mode is set to external-CLK(2).
-
internal(1)—Use when the Clock Mode is set to either internal-CLK(1) or networtk-CLK(0).
•
FP Switch (Front Panel
-
disabled (0)—disables the toggle switches on the front panel of the 2701RC rack card
-
enabled(1)—enables the ability to use the front panel toggle switches
•
In Band Loops, the two in-band loops are the CSU loop and the V.54 loop.
-
disabled(0)—neither loop can be enabled.
-
enabled(1)—one of the in-band loops can be enabled depending on the selection of the RDL Type.
•
RDL Type
-
csu(1)—Selects the in-band loop which is initiated as the standard CSU loopback.
-
v54(2)—functions as defined by the V.54 remote Loopback.
•
Test Mode DTE, refers to the initiation of loopbacks via one of the DTE signals.
-
disabled(0)—no loopbacks can be initiated by a DTE signal
-
enabled(1)—Loopbacks can be initiated by a DTE signal.
Refer to section
“Applying a template”
on page 164 to activate the template.