![background image](http://html1.mh-extra.com/html/patton-electronics/multiport-asynchronous-statistical-multiplexer/multiport-asynchronous-statistical-multiplexer_getting-started-manual_4037272025.webp)
Installing the Model 3034/3038
25
Model 3034/3038 Getting Started Guide
3 • Model 3034/3038 installation
Connecting the 10/100Base-T Ethernet LAN and WAN cables
The Model 3034/3038 has automatic MDX (auto-crossover) detection and configuration on all Ethernet
ports. Any of the ports can be connected to a host or hub/switch with a straight-through or cross-over wired
cable.
1.
Connect to the subscriber port of the broadband access modem (Cable, WLL) to
ETH 0/0
.
2.
Connect port ETH 0/1 to your LAN.
For details on the Ethernet port pinout and cables, refer to
Appendix C, “Cabling”
on page 49 and
Appendix
D, “Port pin-outs”
on page 52.
Connecting the Composite port
Models with a V.35 port
(3034/C and 3038/C)
.
1.
Plug the V.35 WAN cable’s DB-25 end into the units’s
Composite
connector.
2.
Plug the other end of the cable into the V.35 device.
Figure 6. V.35 interface models
Models with an X.21 port
(3034/D and 3038/D)
.
1.
Plug the X.21 WAN cable’s DB-15 male end into the DB-15 connector (labeled
Composite)
on the
3034/3038.
2.
Plug the other end of the cable into the X.21 device.
Figure 7. X.21 interface models
Models with a T1/E1 port and BNC Connectors
(3034/K and 3038/K)
.
Connecting to the T1/E1 RJ-48C port
3038/ C Models - V.35
Ethernet ports
V.35
interface
RS-232 ports
Power
connector
Reset
button
Ethernet ports
Power
connector
Reset
button
3038/ D Models - X.21
RS-232 ports
Ethernet ports
X.21
interface
Power
connector
Reset
button