Cable installation
25
Model 3224 G.SHDSL IpDSLAM Installation Guide
2 • Hardware installation
Connecting the Ethernet ports
The IpDSLAM has two 10/100 Ethernet interfaces for connection to your LAN (see
figure 9
). The Ethernet
port will autosense the correct speed of the local LAN and automatically negotiate half- or full-duplex opera-
tion. This section describes connecting the IpDSLAM to the Ethernet LAN via an Ethernet hub, switch, or
workstation.
Figure 9. Model 3224 network and configuration ports
Connecting the 10/100Base-T Ethernet ports to an Ethernet switch or hub
The 10/100Base-T Ethernet ports (see
figure 9
) are designed to connect to an Ethernet switch or hub. The
Ethernet RJ-45 pin and signal definitions for the IpDSLAM or for a NIC card in a workstation/PC are shown
in
figure 10
. Connect a straight-through CAT-5 cable (one wired as shown in
figure 10
) between the IpD-
SLAM and the hub/switch.
Figure 10. Straight-through RJ-45-to-RJ-45 Ethernet cable diagram
RJ-45 Jack
(TX+) Transmit Data +
(TX-) Transmit Data -
(RX+) Receive Data +
4
5
(RX-) Receive Data -
7
8
1
2
3
4
5
6
7
8
Direction
Signal Name
3
1
2
6
Output
Output
Input
Input
Summary of Contents for Diamond Edge 3224
Page 8: ...About this guide Model 3224 G SHDSL IpDSLAM Installation Guide 8...
Page 18: ...1 Introduction Model 3224 G SHDSL IpDSLAM Installation Guide 18 Power Considerations...
Page 41: ...41 Chapter 5 Maintenance Chapter contents Introduction 42 Replacing a power supply 42...
Page 49: ...49 Appendix A Network Ports RJ 21X connector pin out Chapter contents Introduction 50...