![background image](http://html1.mh-extra.com/html/patton-electronics/diamond-edge-3224/diamond-edge-3224_installation-manual_4068335023.webp)
Cable installation
23
Model 3224 G.SHDSL IpDSLAM Installation Guide
2 • Hardware installation
Do the following:
1.
Connect the earth ground of the AC source to the grounding stud on the IpDSLAM as described in the
section
“Grounding the Model 3224—AC and DC Power Supplies”
on page 21.
2.
Install a power cable into an IEC-320 connector (see
figure 6
on page 22).
3.
Rotate the power cable retainer clip so it secures the power cable plug in the IEC-320 connector as shown
in
figure 7
.
Figure 7. Power cable retainer clip
4.
Repeat steps 2 and 3 to install the remaining power cable.
Power cable
retainer clip
Grounding stud
Summary of Contents for Diamond Edge 3224
Page 8: ...About this guide Model 3224 G SHDSL IpDSLAM Installation Guide 8...
Page 18: ...1 Introduction Model 3224 G SHDSL IpDSLAM Installation Guide 18 Power Considerations...
Page 41: ...41 Chapter 5 Maintenance Chapter contents Introduction 42 Replacing a power supply 42...
Page 49: ...49 Appendix A Network Ports RJ 21X connector pin out Chapter contents Introduction 50...