![background image](http://html1.mh-extra.com/html/patton-electronics/diamond-edge-3224/diamond-edge-3224_installation-manual_4068335030.webp)
3 • Configuring the IpDSLAM for operation
Model 3224 G.SHDSL IpDSLAM Installation Guide
30
Introduction
Introduction
This chapter contains the following procedures for configuring the Model 3224 IpDSLAM for operation:
•
“Configuration prerequisites”
—lists the items you need to have on hand before configuring the IpDSLAM.
•
“Preparing the IpDSLAM for configuration”
—describes setting up the IpDSLAM IP address and netmask
parameters.
Configuration prerequisites
You will need the following to configure the IpDSLAM:
•
A PC workstation with a serial port and a VT-100 terminal emulation software program such
as HyperTerminal
TM
•
A PC with an Ethernet port and a WWW browser connected to the remote access server’s local LAN
•
The IP address and subnet mask for the IpDSLAM’s Ethernet port
Preparing the IpDSLAM for configuration
Before the IpDSLAM can be configured the IP address and the netmask needs to be set up. This setup is done
through the RS-232 CONFIG port on the IpDSLAM.
1.
If you have not done so already, install the supplied DB-9-to-RJ-45 cable between the IpDSLAM RS-232
port (see
figure 9
on page 25) and an open serial port on your computer.
2.
Start a new VT-100 terminal session configured with the following characteristics:
– Direct connection to COM port
– 19.2 kbps
– 8 bits
– No parity
– 1 Stop bit
– No flow control
Summary of Contents for Diamond Edge 3224
Page 8: ...About this guide Model 3224 G SHDSL IpDSLAM Installation Guide 8...
Page 18: ...1 Introduction Model 3224 G SHDSL IpDSLAM Installation Guide 18 Power Considerations...
Page 41: ...41 Chapter 5 Maintenance Chapter contents Introduction 42 Replacing a power supply 42...
Page 49: ...49 Appendix A Network Ports RJ 21X connector pin out Chapter contents Introduction 50...