![background image](http://html1.mh-extra.com/html/patton-electronics/diamond-edge-3224/diamond-edge-3224_installation-manual_4068335020.webp)
2 • Hardware installation
Model 3224 G.SHDSL IpDSLAM Installation Guide
20
Introduction
Introduction
This chapter contains the following procedures for installing the Model 3224 IpDSLAM:
Note
Before installing the IpDSLAM, you will need to obtain the line type
and encoding of any WAN uplink port from your local telephone
company (telco).
•
“Unpacking the Model 3224 IpDSLAM”
—lists the contents in the IpDSLAM shipping container
•
“IpDSLAM chassis installation”
—describes installing the IpDSLAM on a flat surface or in a standard 19-
inch rack
•
“Cable installation”
on page 21—describes installing the power and network interface cables
•
“Completing the hardware installation”
on page 27—describes testing the IpDSLAM hardware to verify
that it is ready for software configuration
Unpacking the Model 3224 IpDSLAM
Inspect the shipping carton for external damage. Note any damage before removing the container contents.
Report equipment damage to the shipping carrier immediately for claim purposes. Save all packing materials in
case you need to return an item to the factory for servicing.
•
The IpDSLAM comes with the following items:
•
The Model 3224 Packet Digital Subscriber Loop Access Multiplexer (IpDSLAM)
•
An RJ45-to-RJ45 cable for use with the console and Ethernet ports
•
A DB9-RJ45 (EIA-561) adapter for connecting a PC's serial port to the console port
•
Rack mounting kit with rack ears and mounting hardware
•
Model 3224 IpDSLAM Getting Started Guide
•
CD-ROM containing product literature and the
IpDSLAM Administrator's Reference Guide
Note
Power cables are shipped separately from the Model 3224.
IpDSLAM chassis installation
Do the following:
1.
If you have not done so already, remove the IpDSLAM from its shipping container.
Note
The IpDSLAM should be placed as close as possible to the termina-
tion jack provided by the Telco. Avoid installing the IpDSLAM in a
location where the power cords or network interface cables could be
accidentally disconnected. The location should be well ventilated. Do
not block the IpDSLAM’s cooling vents.
2.
If you are installing the DACS in a 19-inch rack, go to step 3. Otherwise, place the DACS at the desired
location, then go to
“Cable installation”
on page 21.
Summary of Contents for Diamond Edge 3224
Page 8: ...About this guide Model 3224 G SHDSL IpDSLAM Installation Guide 8...
Page 18: ...1 Introduction Model 3224 G SHDSL IpDSLAM Installation Guide 18 Power Considerations...
Page 41: ...41 Chapter 5 Maintenance Chapter contents Introduction 42 Replacing a power supply 42...
Page 49: ...49 Appendix A Network Ports RJ 21X connector pin out Chapter contents Introduction 50...