3 • Configuring the 3324 for operation
Model 3324 User Guide
54
Administrator
menu, then select enable STP. It is recommended that you enable STP on your Model 3324 to ensure a single
active path on your network. Additionally, you can view STP information about the Root Bridge by clicking
on Root Bridge Information (see
figure 24
).
Figure 24. Root Bridge Information
You can also view STP port status by clicking on STP Port Status
Figure 25. STP Port Status
You can set new values for the STP parameter in the Configuring Spanning Tree Parameters screen. Once the
new values are set be sure to click the Apply button to save the configuration. The parameters that can be
modified are as follows:
•
Priority:
This value is used to identify the root bridge. The bridge with the lowest value has the highest pri-
ority and will be selected as the root bridge. The valid range is between 1-65,535.
•
Max Age:
This value represents the number of seconds a bridge waits without receiving STP configuration
messages before attempting a reconfiguration. The valid range is between 6-10.
•
Hello Time:
Hello Time represents the number of seconds between the transmission of STP configuration
messages. The valid range is a between 1-10.
Summary of Contents for 3324
