125
126
GB
GB
8
To fit spool and line complete
Remove old spool .
Place new spool into cutting head with cut
out areas of the spool in line with eyelets.
Release line from cleat and feed line
through eyelet.
Refit the spool head cover.
Your Trimmer is designed to use only line
with a maximum diameter of 1.2mm.
IMPROTANT: Leave approximately 100mm
of line unwound and place into cleat.
Care should be taken to ensure that the line
is neatly coiled on the spool. Failure to do so
will impair the efficiency of the automatic line
feed. (See Fig L1,L2,L3)
Then fit spool as described in “To fit spool
and line complete”.
9
To fit nylon line only
WARNING!
Take approximately 4m of line.
Insert line into the spool holes and wind line
in the direction of the arrows on the top of
spool .( See Fig K)
VI- Maintenance
1. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a
dry cloth.
2. Always check the cutting head and guard
before each use.
3. Always store your power tool in a dry
place.
4. Keep the motor ventilation slots clean.
5. Have the unit professionally repaired
should any damage parts.
VII-Troubleshooting
VIII- Warranty
Although your new grass trimmer is really
easy to operate .If you do experience
problems, check the following:
Dear customer, our products are going under
strictly qualitycontrols.
In case of misfunction, which are pointing out
material or manufacturing faults, please
contact your Hornbach store.
To enforce warrenty claims obtains :
1. These conditions are ruling additional
warrenty performances and are free of
charge.
Tool runs slowly
• Check that the spool housing can rotate
freely. Carefully clean it if necessary.
• Check that the cutting line does not
protrude more than 9 cm from the spool
housing. If it does, cut it off so that it just
reaches the line trimming blade.
If the trimmer is not cutting properly
Check the condition of the cutting head, if the
cutting line is too short or cutting head
damaged.
Note: Do not use damaged cutting head.
If a fault is suspected return the trimmer
to an authorized dealer for repair.
WARNING!
Before proceeding, unplug the tool.
The warrenty rules given by law will
remain untouched.
2. The warrenty performance is limited on
material or manufacturing faults and the
elimination of those or alternativly
exchange of the product. As our products
are not constructed for professional use,
we see the warrenty contract as not valid,
if the product is used under those
circumstances.
Excluded are ; warrenty claims for
transportation damages,damages coming
from non-observance of the manual ( like
connection to wrong voltage or wrong
electricity ),unprofessional installation,
incorrect use( like overstressing the
product or usage of not approved tools or
accessories ), non-observance of the
maintanace and safety rules ), infiltration
of foreign objects ( like sand, stones or
dust ), wrong force or man inducted events
( like damages caused by falling down ),
plus normal accepted attrition ( like battery
packs, blades and so on ). The warrenty
claim expires if intrusions were already
done.
3, The warrenty period is three years and is
starting with the date of purchase of the
product. warrenty claims must be raised
within two weeks after realising the defect.
Warrenty claims coming later are
excluded. The warrenty period is neither
extended after repair or exchange nor a
new warrenty period is started fort he
product or possible spare parts.
4. To enforce warrenty claims contact your
Hornbach store and show your bill as an
original or another dated buying proof.
Therefore keep your receipt accurately.
Explain the reason of your claim as good
as possible. Is the defect part of our
warrety performance, you will get a
repaired or new product at once.
