Pattfield Ergo Tools PE-BS 25, Instructions Manual

Page: 173 / 176

VIII - TROUBLESHOOTING
Problem Possible cause Fault correction
There is not enough fuel in the
fuel tank
Add fuel
The primer has been not
pressed at cold start
Press the primer and
restart
The primer has been not
pressed at warm start
Press the primer and
restart
The spark plug is wet Dry the spark plug
Engine does not start
The spark plug is damaged
Replace the spark
plug
There is not enough fuel in the
fuel tank
Add fuel
The cutting means are blocked Remove the blockage
Engine stops
The engine speed don’t fit the
terrain requirements
Increase the engine
speed
The cutting means are not
sharp enough
Replace the cutting
means.
The cutting means are not
fitted correctly
Fit the cutting means
correctly
Cutting height is wrong
Adjust the cutting
height
Bad cutting performance
The cutting/trimming guard is
clogged
Clean the
cutting/trimming
guard
The cutting means are broken
Replace the cutting
means
The flanges on the cutting
means are loosen
Tighten the flanges
The flanges on the cutting
means are broken
Replace the flanges
Excessive vibration/noise
or big smoke came out
The mixture scale and oil type
is wrong
Re-fill fuel and oil
mixture into the tank