Pattfield Ergo Tools PE-BS 25, Instructions Manual

Page: 171 / 176

NOTE: Petrol deteriorates over time.
Engine starting may be difficult if you
use petrol kept for more than 30 days.
Always empty the fuel tank when
storing over 30 days.
6 FUEL FILTER
The fuel tank of this petrol brush cutter is
fitted with a filter located at the free end of
fuel pipe. Periodically ask an authorised
service centre or similar qualified person to
check and replace it.
7 SPARK PLUG
1) Inspect the spark plug at least every 25
hours, clean and replace with a new one if
necessary.
2) Unplug the spark plug connector by
pulling.
3) Loosen the spark plug with the spark
plug wrench and remove it.
4) The colour of the electrode shall be light
brown.
5) Remove debris like oil with a brass
brush. Do not force the brush to avoid any
damage.
6) Dry the spark plug with a soft cloth if it is
wet.
7) Check the spark plug gap. It should be
0.6-0.7mm.(Fig.24)
8) Replace with a new spark plug if you
find damages like cracks or a splintered
insulation.
9) Screw in the spark plug by hand, and
then tighten it with a spark plug wrench.
WARNING! Do not over tighten
the spark plug to avoid any damage!
8 CARBURETTOR
The carburettor is readjusted by the
manufacturer. Should it be necessary to
make any changes please contact an
authorised service centre or similar
qualified person. Do not attempt to make
adjustments by yourself.
9 SILENCER
Should it be necessary to make any
changes or replacement, please contact
an authorised service centre or similar
qualified person.
10 REPLACING THE CUTTING BLADE
When the blade is blunt or damaged, it will
effect the tools performance, so you must
replace the blade immediately.
NOTE: If one side of the blade is
damaged, simply remove, turn the
blade over and re  t. Use only
recommended cutting blades.
11 REPLACING SPOOL
1) If the cutting line is used up the spool
must either be replaced by one of the
same type or the cutting line must be
refilled.
2) To refill the cutting line lay the petrol
brush cutter and grass trimmer on a flat
stable surface with its spool assembly
facing upwards.
3) Open the spool assembly by
unscrewing the bumper clockwise.(Fig.25)
4) To replace the spool simply remove from
the spool assembly and replace with a new
one of the same type that
recommended.(Fig.26)
5) To replace the line take out the spool
and remove the remaining cutting line.