Paton STANDARDTIG-160, User Manual

Page: 106 / 115

PATON StandardTIG DC MMA/TIG/MIG/MAG
- 104 -
Caution! If you hold down button 3 for a long time, when you see the name of the
function, after about 10 seconds, a countdown 333...222...111 will start on the digital display
warning about resetting all settings of the current mode. This will be reviewed in the next
paragraph.
6.2 SWITCHING TO THE REQUIRED WELDING MODE
Pressing button 4 leads to switching to the next welding mode in a circle, this can be
seen on display 1 on the front panel.
6.3 RESET ALL FUNCTIONS OF THE WELDING MODE USED
Situations may occur when the unit's settings have somewhat confused the user. In
order to reset them to the standard factory settings, it is enough to hold down button 3 for
more than 10 seconds (ignore the animation of lock symbols). As mentioned in the previous
paragraph, the scoreboard will start counting down 333...222...111 and when "000" is
reached, all settings of the current welding mode will be updated to factory settings.
Reset parameters for each welding mode are made separately. This is provided for
convenience, so as not to reset individual settings in the other two modes.
6.4 CHANGE PROGRAM NUMBER IN CURRENT WELDING MODE
In each MMA, TIG, and MIG / MAG welding mode, it is possible for the user to save
up to 16 different presets. The current preset (program) number is displayed in the upper
right corner of the LCD of the source on the front panel. At the moment of the first switching
on of the machine, the program is always under No. 1 for each welding mode. All changes in
the setting of the machine in this welding mode and the current program number are saved.
To switch to another program number and start setting again from the basic parameters,
just press button
3 and if the function selection menu is locked, then the LCD displays the
current program number, which can be changed up or down using buttons 2 . If the function
selection menu is not locked, for example, the user just before that changed the additional
parameters of the functions described in clause 6.1, then it is necessary to lock the function
selection menu by holding button 3 for more than 3.5 seconds, in the same way as when
unlocking, when the LCD will show closing locks, after this operation the menu will be locked
and now you can try again to change the program number using button
3 . In this case, all the
parameters of the previous program will be saved and you can always return to it again.
7. GENERAL LIST AND SEQUENCE OF FUNCTIONS
MMA welding mode
0) main display parameter CURRENT = 90A (by default)
a) 8 ... 160 А (change step 1 А ) for StandardTIG-160
b) 10 ... 200 А (change step 1 А ) for StandardTIG-200
c) 12 ... 250 А (change step 1 А ) for StandardTIG-250