Paton STANDARDTIG-160, User Manual

Page: 107 / 115

- 105 -
PATON StandardTIG DC MMA/TIG/MIG/MAG
d) 12 … 270А (change step 1 А ) for StandardTIG-270-400V
e) 14...350 А (change step 1 А ) for StandardTIG-350-400V
1) "Hot start" power = 40% (by default)
a) 0[OFF] ... 100% at low currents (change step 5%)
2) "Hot start" time = 0.3 sec (by default)
a) 0.1 ... 1.0 sec (change step 0.1 sec)
3) “Arc Force” power = 40% (by default)
a) 0[OFF] ... 100% at low currents (change step 5%)
4) “Arc Force” trigger level = 12V (by default)
a) 9 ... 18V (change step 1V)
5) slope of current-voltage characteristic = 1.4V/A (by default)
a) 0.2 ... 1.8 V/A (change step 0.4 V/A)
6) short arc welding = OFF (by default)
a) ON
b) OFF
7) voltage reduction unit = OFF (by default)
a) ON
b) OFF
8) current pulsation power = OFF (by default)
a) 0[OFF] ... 80% (change step 5%)
9) current pulsation frequency = 50Hz (by default)
a) 0.2 ... 500Hz (dynamic step)
10) pulse/pause ratio (duty cycle) – it is the percentage of the current pulse to the period of
repetition of these pulses = 50% (by default)
a) 20 ... 80% (change step 5%)
TIG welding mode
0) main displayed parameter CURRENT = 100A (by default)
a) 8 ... 160 А (change step 1 А ) for StandardTIG-160
b) 10 ... 200 А (change step 1 А ) for StandardTIG-200
c) 12 ... 250 А (change step 1 А ) for StandardTIG-250
d) 12 … 270А (change step 1 А ) for StandardTIG-270-400V
e) 14...350 А (change step 1 А ) for StandardTIG-350-400V
1) torch button mode = [2T] (by default)
a) [LIFT] - TIG-LIFT contact striking mode
b) [2T] - non-contact striking mode, TIG-2T button mode
c) [4T] - non-contact striking mode, TIG-4T button mode
2) pre-purge time = 2.0 sec (by default)
a) 0.5 ... 25.0 sec (change step 0.1 sec)
3) gas post-purge time = 3.0 sec (by default)
a) 1.0 ... 25.0 sec (change step 0.1 sec)