HEATER STAND AND LOCATION
The appliance can be anchored with the use of the ground
fixing bracket.
To fix the heater into the ground attach the 3 pcs ground fixers
using M6 x 10mm (length) fixer bolts. See figure 2.
Fortification in the Ground
Figure 2
TO STORE THE HEATER
1. Remove the regulator from the gas tank.
2. Inspect the tank for any damage. If you suspect that your tank is
damaged, return it to your gas supplier.
3. Store the gas tank in a well ventilated area. Never store the gas
tank below ground i.e. basement.
10
STEP 4 :
4-1 Fit the LPG hose onto the burner
gas inlet connector as shown.
4-2 Tighten the jubilee clip around the
hose and gas inlet connector.
4-3 Tread the hose down the post assembly.
4-4 Fix the burner base vertically with
the post and install 4 pieces of
M6 x 10mm bolts and tighten.
STEP 5 :
5-1 Fit the regulator to hose and attach
jubilee clip and tighten as shown.
5-2 Put the 3 pieces of reflector washer into
the supporting top bolt of burner.
5-3 Assemble canopy according to canopy
instructions.
STEP 6 :
6-1 Put the reflector canopy onto the top
of the burner aligning through the
3 supporting bolts.
6-2 After placing the reflector canopy,
place 3 washers and 3 wing nuts
on the supporting bolts.
6-3 Tighten each of the wing nuts.
7
SETTING UP
STEP-BY-STEP PROCEDURE
