January 2021
52
Pathport® QUATTRO - 63XX - Manual
Security Mode
Wait for Pathscape to Secure
Local Configuration Only
Disable Security
Disable Security
Cancel
Opt Out of Security
• From the
Security Mode
menu shown on the LCD, turn the encoder to select
Disable Security
. In the submenu, confirm
by selecting
Opt Out of Security
again.
• You will then be able to access the menus. The device will appear in Pathscape with the Security Domain shown as
“
Disabled by User
”. It will behave like a legacy device; all properties will be Read/Writable.
• On the front panel display, the bottom line will show “
Security: Disabled by User
” as a reminder and warning.
MAIN DISPLAY MESSAGES
When idle, the main LCD will show the device soft label (Name) and its IP address. When the device has an active network
connection, “
ETH: Link Up
” will be shown at the bottom of the LCD. If the device does not have a network connection,
“
ETH: Link Down
” will be shown.
If the switch has been set to Disable security features, it will show “
Security: Disabled by User
” as a reminder and
warning.
<Gateway Name>
IP: X.X.X.X/Class
<Ring Protect Status/Security
warning if disabled>
Rack QUATTRO
IP: 10.30.146.58/8
ETH: Link Up
The gateway name will be that soft label given to the device in Pathscape. If no soft label has been assigned to the gateway,
its IP address will be shown as its name in the top line, in addition to the middle line.
The subnet class, shown after the IP address on the middle line, will be “/8”, “/16” or “/24”. These are respectively, Class A
subnet mask of 255.0.0.0, a Class B subnet mask of 255.255.0.00, and a Class C subnet mask of 255.255.255.0.
Summary of Contents for Pathport QUATTRO 63 Series
Page 7: ......
