Pathport® QUATTRO - 63XX - Manual
January 2021
49
If you choose
Wipe All Configuration
it will completely restore the device to the same state as it left the factory. This will erase
any Device Restore Point saved on the unit.
You can also choose
Keep Restore Point
to preserve any saved Restore Point, but be aware that the restore point could have
saved properties that are the cause of the communication loss, and recalling that restore point could cause the same issues.
The device will then reboot, having reset itself to the Factory settings. Before configuration can be restored, the unit’s Security
Mode must be configured (add to a Security Domain, enable Local Configuration Mode, or Disable Security).
FRONT PANEL LOCKOUT
If the device has
Front Panel Lockout
enabled, you will not be able to make changes from the front panel. To address this,
there is a 30-second delay before the LCD Lockout takes effect, after the QUATTRO boots up.
First, hard reboot the device (either unplug and re-plug the DC power source, or power cycle the PoE source, as applicable),
and then
within 30 seconds
after the switch has booted up, perform the above action. After 30 seconds, the front panel UI
will be locked out again.
Summary of Contents for Pathport QUATTRO 63 Series
Page 7: ......
