5
TOOL INSTALLATION
Your Paslode tool comes ready for immediate
use and can be installed by following these steps:
1. SAFETY - All tool operators and their immediate
supervisors must become familiar with the operator
safety instructions before operating the tool. The
instructions are on page 4 of this manual.
2. Included with each tool is a copy of the operation
manual and schematic.
Keep this publication for
future reference. An ownership registration card is
also included. This card must be completed and
returned to Paslode
immediately to register your
ownership.
3. The plastic cap in the air inlet of the tool must be
removed before the male fitting is installed. The fit
-
ting must be a male pneumatic type that discharges
the air from the tool when the air line is disconnected.
4. Install a filter/regulator/lubricator unit, with a
gauge as close as practical to the tool, preferably
within ten feet. Refer to the Air Systems section of
this manual for air hose requirements and lengths.
In general, no other special installation is required.
5. If the operator is working at a bench or table,
it is usually best to run the air line underneath the
bench. A small tray under the benchtop can hold
the fastener supply and the tool when not in use.
6. If this tool does not work when it is first connect
-
ed, do not try to make repairs. Call your Paslode
representative immediately.
TOOL OPERATION
Step No. 1
-
Grasp the nailer handle firmly with
one hand and with the other hand depress the
door latch. Swing the magazine and door open.
Loading of Nails
Step No. 2
-
Remove the retaining tape from the
nail coil and place the nail coil in the magazine with
the tips of the nails against the loading tray and about
4 inches of coil unwound.
Step No. 3
-
Slide the free strip of nails along the
top of the feeder body assembly and feed the nails
over the feed pawls until the first nail is in the nose
raceway.
®
®
Step No. 4
-
Close the magazine cover and then
the gate making sure the gate is latched securely.
®
W A R N I N G
1. Read and understand tool labels and manual.
Failure to follow warnings could result in DEATH or SERIOUS INJURY.
2. Operators and others in work area MUST wear safety glasses with side shields.
3. Keep fingers AWAY from the trigger when not driving fasteners to avoid accidental firing.
4. Know and understand what trigger system you are using. Check manual for triggering options.
5. Never point tool at yourself or others in work area.
6. Never use oxygen or other bottled gases. Explosion may occur.
TG100CSN
Coil Siding Nailer
Paslode, 155 Harlem Ave., Glenview, IL 60025
Use Paslode tetraGRIP
Studless Siding
Nails only
#650867
0.300" (7.6mm)
PATENTED tetraGRIP thread
1.125"
(29mm)
™
