6
：
COMPRESSOR LUBRICATION
Do not add or change oil while the compressor is in operation, use the recommended 30 weight
non-detergent oil only.
6-1
：
OIL FILLING
6-1-1
：
Remove the oil filler plug.
6-1-2
：
Slowly pour the proper oil into the pump crankcase.
6-1-3
：
Always keep oil level between the marks “HIGH” and “LOW” level on the oil stick or on
the red circle of the sight glass.
7
：
START UP PROCEDURE
Do not attempt to operate the air compressor unit without first checking the oil level in the pump,
add oil as required. Serious damage may result from use without oil.
7-1
：
Check to see that nuts and bolts are all snug, this must be done as some fasteners may
become loose in transit.
7-2
：
Check to see if the belt is installed with proper tension.
7-3
：
Check belt tightness so that when pressure is applied at the center, there is 1/2” slack.
7-4
：
Check that type and oil level is correct, user proper compressor lubrication.
7-5
：
Check that compressor is placed on stable, level ground.
7-6
：
Check that crank case breather is clean.
7-7
：
Check that air filter is clean.
7-8
：
Do not place any materials on or against the compressor unit itself.
Doing so will limit the cooling of the air compressor and could lead to
premature failure.
7-9
：
Check that the flywheel is turning in the correct direction.
7-10
：
Open the air receiver outlet ball valve and start the unit. Allow the unit to operate for a
minimum of twenty minutes in this no load condition.
7-11
：
After running the compressor for twenty minutes, close the ball valve and allow the
unit to reach maximum operating pressure. Ensure that the compressor shuts down
at the preset maximum pressure, and the head pressure is released through
pressure switch.
7-12
：
Check the air compressor and piping systems for leakages, and correct as required.
7-13
：
Shut off of all power to the air compressor before attempting any repair or maintenance.
7-14
：
Stop the compressor and check the oil level thru oil gauge. Add oil as required.
7-15
：
Your compressor is ready for use.
7
Summary of Contents for C10060
Page 11: ...11 ...
