59
page 62 for proper disposal.
3. For each replaced EBP, remove the cable retention clip covering
the battery connector(s), as shown in Figure 17 on page 25. Retain
the clips.
4. Plug the EBP cable(s) into the battery connector(s) as shown in
Figure 17 on page 25. Up to four EBPs may be connected to the UPS.
5. Retain the removed clips.
6. Verify that the EBP connections are tight and that adequate bend
radius and strain relief exist for each cable.
Replacing RT UPS and EBPS
1. If the battery fault, the following steps are provided for modular unit to
replace the new battery pack
2. Remove the front cover of the battery box.
3. Remove the connection cables between battery box and UPS. Release the
screw of the baffle of the battery pack as the Fig26 shows, then remove the
baffle from the left or right.
Fig.26 The Installation for baffle of battery pack
4. Grasp the handle in front of the battery pack, take out of it and hold it,
then remove the battery pack as fig. 27 shown.
