Partner SD-730N, Programming Manual

Page: 57 / 64

Introduction 49
Introduction
z
Scanning Modes
„
Trigger Mode0: Trigger button on the bottom of scanner must be
pressed to enable scanning. The light source of scanner turns off and
stops scanning when there is a successful reading or no code is decoded
after the time-out duration elapsed.
„
Trigger Mode1: The trigger button acts as a contact switch. Press the
trigger button to active scanning and release the button stop scanning.
„
Trigger Mode2: The trigger button acts as a toggle switch. Press the
trigger button to active or stop scanning.(Toggle mode)
„
Trigger Mode3: Trigger button on the bottom of scanner must be
pressed to enable scanning. The scanner stops scanning when no code
is decoded after the time-out duration elapsed. (Laser mode)
„
Trigger Mode4: Trigger button on the bottom of scanner must be
pressed to enable scanning. The scanner flashes the light source when
no code is decoded after the time-out duration elapsed. In this mode can
save the power resource and extend the operation life of the light source.
The scanner can be woken up when there is a successful reading or the
trigger button pressed. Flash time setting.
„
Trigger Mode5: The scanner always keeps operation no matter any
duration time and trigger switch.
„
Trigger Mode6: The scanner continuously reads and the same label
readings are allowed without double confirm. The feature can test the
performance of a scanner for reading speed and accuracy.
z
Power-On Music
The scanner will be diagnosed by itself while starting power on. Activate start
beep to indicate a successful self-test to wait the bottom be triggered. The
feature can enable or disable the start beep.
z
Power-On Auto Trigger
The feature can auto trigger the button of scanner to activate the light source
after the successful start beep.
z
Good-Read LED/Beep
After each successful reading the scanner will light green LED and beep
buzzer to indicate the good barcode reading. The green LED and buzzer can
be enabled or disabled active while each good reading. The beep tone of
buzzer can be changed by Beep Tone Adjustment function.
z
Field Control
The scanner can read-out many sets of barcode data on the same scanning
line in the same time if Multi-Field of Field Control were selected. The direction
of read-out code is form left to right even different type symbol code data.
z
Double Confirm (Redundancy)
The feature should be dependant on the symbology and quality of barcodes
read. If enabled, the scanner will require many successful scans to validate
the barcode data. The value of confirm time can be set by Double Confirm
times function at page 15, and the more confirm times the less miss-reading of
codes. Therefore you can select a higher value rather then reducing read-out
speed.