Partner SD-730N, Programming Manual

Page: 58 / 64

50 Introduction
Introduction
z
Code Name Transmission
The feature is useful to show unknown barcode symbologies that include the
readable barcode symbol of scanner. When the enable is selected, the
symbology code name will be shown before the code data. For the data
location, see Data Transmission Flowchart.
z
Code ID Position
The code ID can be transmitted before or after the code data by this selected
when Code ID Transmit enabled. Normally, the position is before the code
data.
z
Code Length Transmission
The length of data characters can be transmitted before the code data when
the enable is selected. The total length is a number of barcode data except
Truncate Leading/Ending Digits. The Code Length has two digits.
z
Beep Loudness/Tone/Duration (Set value)
These features can adjust the Good-Read Beep, Tone and Timer which user
favor. The Beep Timer is the duration of beep while code is read successfully.
z
Stand-By Timer (Set value)
Time-out duration of 1 to 99 seconds could be adjusted. The Stand-By Timer
that is valid scanning duration will be effective only when the trigger mode is
operated in Mode0, Mode3 or Mode4.
z
Action/Sleep Timer (Set value)
There are two durations could be effective only when the scanner operated in
Mode4. The scanner will be entry flash operation when no code is read until
Stand-By Timer time-out. The Action Timer is lighting duration and Sleep timer
is blanking duration while light source fleshes. The barcode image can be also
read during flash of light source and then waked up the scanner automatically.
z
Good-Read Delay Timer (Set value)
The feature is for limiting the duration during the same barcode data to be
read continuously, except operated in Mode0 and Mode6. The timer will be
reset when different barcode data is read.
z
Double Confirm Times (Set value)
This feature should be selected according to the symbology and the quality if
barcodes being read. The values of times are successful decoding to validate
the barcode data times. When a higher value is set, the slower the reading
speed and the higher data security.
z
Scan Rate Timer (Set value)
The Scan Rate will affect the CCD (Charge Coupled Device) sensor of
exposure time. The feature can adjust the CCD scan rate to improve the
performance of scanner. When the less value of Scan Rate Timer is set, the
faster scanning response.