Parsun F40 EFI, Maintenance Manual

Page: 100 / 119

95
Disassembly and inspection of bracket
1. Remove the left and right absorber covers, and remove the left and right absorbers and
double-hole absorber fixing nuts.
2. Remove the water unit, oil pan and exhaust manifold seat as a whole from the bracket
3. Remove bracket clamping nut and clamp bracket twin-headed threads.
4. Disconnect the grounding cable and remove the clamp bracket.
5.
Remove the cotter pin Φ2×12 and circlip 9, and remove the long shaft of the locking
frame and the short shaft of the outer frame.
6. Remove the inner and outer frames of the support frame.
7. Pull out the steering carrier assembly and remove the ring gasket, bushing and O-ring.
8. Check the rotary bracket and clamp bracket for cracking or damage. Replace it if
necessary.
9. Check the bushing and ring gasket; Replace it if damaged or cracked.
10.
Check the support frame assemblies A & B for deformation or damage.
Replace it if necessary.
11. Check the left and right absorber rubber for aging, cracking, or degumming. Replace it
if necessary.
Disassembly and inspection of water unit
1. Drain the oil.
2. Remove the mounting bolts on the water and underwater, and remove the water unit.
3. Remove the exhaust manifold block and oil pan.
4.
Remove the coarse filter assembly and coarse filter bracket from the exhaust
manifold seat.
5. Remove the exhaust manifold, drain screw, rubber sleeve of the oil drain hole,
exhaust manifold rubber sleeves A&B and exhaust manifold block from the oil pan.
6. Remove the double-hole absorber, exhaust partition, round rubber ring of water pipe
and water pipe.
7. Check the water unit housing and oil pan for cracking or damage. Replace it if
necessary.
8. Check the exhaust manifold for cracking or damage. Replace it if necessary.
9.
Check the exhaust pipe sealing ring and exhaust manifold rubber sleeves A&B for
aging and cracking. Replace it if necessary.