Parmco HX-2-2NF-INDUCT, Installation And Operating Instructions Manual

Page: 27 / 28

24
Connec � ng the hob to the mains power supply
This hob must be connected to the main power supply by a quali fi ed personnel.
B efore connec � ng the hob to the mains power supply , check that:
1. the domes � c wiring system is suitable for the power drawn by the hob.
2. the voltage corresponds to the speci fi ca � ons provided in the manual and data label.
3. the power supply cable sec � ons can withstand the load speci fi ed on the ra � ng plate.
To connect the hob to the mains power supply , do not use adapters , reducers , or branching devices ,
as they can cause overhea � ng and fir e. The power supply cable must not touch any hot parts and
must be posi � oned so that its temperature will not e x ceed 75 ˚ C at any point.
Check with an electrician whether the domes � c wiring system is suitable without altera � ons.
Any altera � ons must only be made by a quali fi ed technician.
The power supply should be connected in compliance with the relevant local standard.
Blue
Bronw
Yellow/Green
PE
N
L
220-240V
HX-2-2NF-INDUCT
HX - 2 - 6NF - INDUCT
CONNECTION DIAGRAM
Caution! Voltage of heating elements 220-240V
Caution! In the event of any connection the safety
Wire must be connected to the E terminal.
Recommended
type of
connection lead
L1 N1 N2 L2
E L N
L1 N1 N2 L2