Parkside PWSAM 20-Li A1, Translation Of The Original Instructions

Page: 38 / 178

GB
38
• before checking the device, clean-
ing it or performing maintenance
work on it
•
Only use accessories recom-
mended by PARKSIDE. Unsuitable
accessories may cause electric shock
or fire.
Residual risks
There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
may occur in connection with the type and
design of this power tool:
• Lung damage if suitable respiratory
protection is not worn.
• Hearing damage if suitable ear protec-
tion is not worn.
• Health injuries resulting from the effect
of vibration on the hands and arms in
the event that the device is used over
a longer period of time or is not used
and maintained properly.
• Damage to health as a result of:
• touching the area of the grinding
tool which is not covered;
• ejection of parts of workpieces or
damaged grinding discs.
WARNING! Danger due to electro-
magnetic field generated while the ma-
chine is in operation. Under certain cir-
cumstances, this field may negatively af-
fect active or passive medical implants.
In order to reduce the danger of serious
or fatal injuries, we recommend that indi-
viduals who wear medical implants should
consult their doctor and the manufacturer
of the implant before operating the ma-
chine.
Preparation
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
Control elements
Familiarise yourself with the operating ele-
ments before using the device for the first
time.
•
Spindle lock (4)
• Locks the spindle when attaching/
removing the attachment tool.
•
On/Off switch (5)
• Switching on: Press down and push
forward
• Lock: Tilt down in front
• Switching off: Release; if locked:
press at the back
Attaching and removing the
attachment tool
Notes
•
DANGER!
Risk of injury! Only use
attachment tools recommended by the
manufacturer.
• Cutting and grinding discs
• diameter: ≤ 76 mm
• Thickness: ≤ 4 mm
• Only use undamaged attachment tools.
Tools required
• Allen key (14)
Procedure (Fig. A)
1. Press and hold the spindle lock (4).
2. Loosen the clamping screw (15) with
the hex key (14). You can release the
spindle lock (4).
3.
Removing attachments:
Remove
the attachment tool from the mounting
flange (19).
Fitting attachments:
Place the at-
tachment tool on the mounting flange
(19).
The label on the cutting/grinding disc
should always face the tool. The run-