Parkside PSG 85 A1, Translation Of Original Instructions

Page: 9 / 90

9 GB/CY
Check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting and any other conditions that
may affect its operation.
A guard or other part that is damaged
should be properly repaired or replaced by
an authorized service centre unless other-
wise indicated in this instruction manual.
Have defective switches replaced by an
authorized service centre.
Do not use the tool if the switch does not
turn it on and off.
21. Warning
The use of any accessory or attachment
other than one recommended in this instruc-
tion manual may present a risk of personal
injury.
22. Have your tool repaired by a
qualified person
This electric tool complies with the relevant
safety rules. Repairs should only be carried
out by qualified persons using original
spare parts, otherwise this may result in
considerable danger to the user.
The following residual risks remain in spite of
the measures to integrate safety in the design,
safety precautions and the complementary pro-
tective measures: The grinding disc will continue
running after switching off the tool. Risk of injury.
Additional safety notes
Only plug the product into a socket with a
residual-current-operated protective device
(RCD) with a maximum rated leakage cur-
rent of 30 mA.
Keep the mains and extension cable away
from the grinding disc and the saw chain.
Immediately unplug from the socket if dam-
aged or cut. Do not touch the lead until dis-
connected from the mains. Risk of electric
shock!
Visually inspect the grinding disc prior to use.
Do not use grinding discs with chips, tears
or any other damage. Replace the grinding
disc if worn.
Never operate the product without visual
cover.
Do not use the product when fatigued or
under the influence of alcohol or medica-
tions. Always take a break in due time.
Do not use the product in explosive atmos-
pheres or where sparks, fire, explosion,
etc. may occur. Failure to observe these in-
structions poses a risk of fire or explosion.
Be sure to keep the vents clear when work-
ing in dusty environments.
Keep your hands away from the grinding
disc and cutting teeth during use. Do not
move the saw chain by hand. Risk of injury.
Never place your fingers between the
grinding disc and rotary table or between
the grinding disc and the visual cover.
Crushing hazard.
The saw chain will become hot during use.
Never touch the processed area - risk of
burns.
Only use grinding discs recommended by
the manufacturer. Do not use saw blades.
Switch off the product and unplug from the
mains
- to remove a jammed insertion tool,
- if the mains cable is damaged or entangled,
- if you notice unusual noise.
Before use
Note: Remove all packaging material from the
product.
The operator should stand in front and stay
close to the power tool to prevent overreach.
Installation
Note: Always use the included screws
(M10 x 60) to secure the product.