Parkside PPS 40 B2, Operation And Safety Notes

Page: 17 / 145

17 GB/CY
„
It must be operated in a dry and well
ventilated working environment.
• Connecting compressed air
PLEASE NOTE!
f
This device is designed for operating
pressure (output pressure at the com-
pressor) of up to 6.3 bar. Please bear in
mind that the pressure can lower while
setting the air pressure. Thus, in a hose
length measuring 10 m and an internal
diameter of 9 mm it drops by approx.
0.6 bar.
The compressed air source must have a filter
and regulator.
„
Connect the compressed air hose 16 on
the back of the plasma cutter 1 to the
compressed air connection 20 . To do so,
insert the side of the compressed air hose
16 into the compressed air connection 20
of the plasma cutter 1 without a quick
connector (see Fig. I).
„
The pressure can be set via the knob 21
on the condensate separator (see
Fig. I-L). Select a pressure of 4–4.5 bar.
„
In order to release the compressed air
hose
16 , you must press the locking
mechanism of the compressed air connec-
tion
20 and pull out the compressed air
hose 16 at the same time (see Fig. I).
• Connecting the cutting torch
„
Insert the plasma burner plug 7 into the
plasma burner connection socket 12
and tighten the union nut hand-tight
(see Fig. A+B).
„
Insert the plasma burner power plug 6
into the plasma burner power socket 10
and tighten the union nut hand-tight
(see Fig. A+B).
• Connecting the ground cable
Connect the ground terminal plug 5 with
the ground terminal - connection socket 11 .
Make sure that the connecting shaft is first
connected and then turned. The connecting
shaft must face upwards when plugging in
the ground cable plug
5 . After plugging in,
the connecting shaft must be rotated in a
clockwise direction until it reaches the stop,
in order to lock it in place (see Fig. A+B).
This does not require force!
• Fitting the removable roller
guide (optional)
Push the removable roller guide 23 over the
nozzle clamping sleeve 8b , until the locking
screws
23a
are completely above the black
area of the plasma burner 8 (behind the
gap at the back of the nozzle clamping
sleeve
8b ) (see Fig. A+B). Now fix the
locking screws
23a
. The guide rollers
23c
are
now positioned such that the required
distance between the workpiece and burner
sleeve
8c is set. The roller guide is then fixed
in place 23 by tightening the fixing screws
23b
(see Fig. N). Make sure that both guide
rollers
23c
are always set to the same height,
in order to enable straight cutting. You can
see a correctly fitted roller guide in Fig. N.
Before use
327358_Plasmaschneider_PPS_40_B2_content_LB7.indb 17 13.09.2019 08:42:44