Parkside PPS 40 B2, Operation And Safety Notes

Page: 11 / 145

11 GB/CY
come into contact with
flammable material.
„
Protect yourself and others
from flying sparks and hot
metal.
„
Please be careful because
sparks and hot materials can
easily fall through small gaps
and openings while cutting
and land on adjacent areas.
„
Please be aware that cut-
ting on a ceiling, floor or a
partition can cause a fire on
the opposite side that is not
visible.
„
Connect the power cable using
the shortest route with a socket
situated close to the workplace
to prevent the power cable
from being spread across the
whole room and located on a
surface which could cause an
electric shock, sparks or fire
outbreak.
„
Do not use the plasma cutter
to defrost frozen tubes.
Risk of electric shock:
WARNING!
f
Electric shock from the cutting
electrode can be fatal.
„
Do not use the plasma cutter
when it is raining or snowing.
„
Wear dry insulating gloves.
„
Do not touch the electrodes
with bare hands.
„
Do not wear wet or damaged
gloves.
„
Protect yourself from electric
shock with insulation against
the workpiece.
„
Do not open the device
housing.
„
Additional protection against a
shock from the mains power in
the event a fault can be pro-
vided by using a fault-circuit
interrupter, which is operated
with a leakage current of no
more than 30 mA and covers
all mains-powered devices in
close proximity. The fault-circuit
interrupter must be suitable for
all types of current.
„
There must be means of rapid
electrical isolation of the
cutting power source or the
cutting circuit (e.g. emergency
stop device) which are easily
accessible.
Danger from smoke emis-
sion when plasma cutting:
„
Inhalation of fumes which
result from plasma cutting can
endanger health.
„
Do not keep your head in the
fumes.
„
Use the device in open areas.
Safety instructions
327358_Plasmaschneider_PPS_40_B2_content_LB7.indb 11 13.09.2019 08:42:44