Parkside PDSP 1000 E6, Original Instructions Manual

Page: 10 / 76

GB
│
CY
│ 7 ■ PDSP 1000 E6
Fault/possible cause Remedy
Blocked sand-blasting
material pipes
Check that no lumps of
sandblasting material
are blocking the pipes.
Preferably, use a blow-
out gun to clean
blocked pipes.
(
Wear safety
goggles! ) Also check
the tank outlet opening.
Sand-blasting pattern not as expected
The air is not dry
enough.
Install a water separator
in your compressed air
system.
Sand-blasting material
grain size not uniform Replace sand-blasting
material.
Sand-blasting material
impure Replace sand-blasting
material
The attachment is worn Replace the attachment
Other defects
Please contact an expert or your retailer.
Maintenance and cleaning
WARNING! RISK OF INJURY!
ALWAYS disconnect the appliance
from the compressed air supply
before cleaning it.
■ Always clean the compressed air sandblaster
gun and the blasting medium container
immediately after completing your work. To do
this, blow out the compressed air sandblaster
gun and the blasting medium container
with compressed air.
■ Store the compressed air sandblaster gun
only in dry rooms.
Disposal
The packaging is made from environ-
mentally friendly material and can be
disposed of at your local recycling
plant.
Do not dispose of the appliance in
the normal domestic waste!
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out appli-
ance.
Dispose of the packaging in an environ-
mentally friendly manner. Note the
labelling on the packaging and sepa-
rate the packaging material compo-
nents for disposal if necessary. The packaging
material is labelled with abbreviations (a) and
numbers (b) with the following meanings:
1–7: plastics, 20–22: paper and cardboard,
80–98: composites.
Your local community or municipal
authorities can provide information
on how to dispose of the worn-out
product.