Parkside PASS 3.6 B2, Operation Manual

Page: 24 / 28

21 PASS 3.6 B2
GB
■ Switch off the power tool immediately if the
tool being used gets blocked.
Be prepared
for high reaction moments as these can cause
kick-back.
■ Hold power tool by insulated gripping surfaces,
when performing an operation where the
fastener may contact hidden wiring or its
own cord.
Fasteners contacting a “live” wire may
make exposed metal parts of the power tool
“live” and could give the operator an electric
shock.
■ When working on the appliance, as well as
during transport and storage, always place
the rotation direction switch in the middle
position (locked).
This will prevent unintentional
activation of the device.
■ This appliance is not intended for use by people
(including children) with reduced physical,
sensory or mental abilities or for those without
experience and/or knowledge, unless they are
supervised by a person responsible for their
safety or they have been instructed in its use.
Children should be supervised to ensure that
they do not play with the appliance.
Original accessories/additional
equipment
■ Use only the additional equipment and acces-
sories detailed in the operating instructions.
The use of tools and accessories other than
those recommended in the operating instruc-
tions could lead to an increased risk of personal
injury for you.
Initial operation
Charging the appliance
Only for interior use!
NOTE
► The battery is supplied partially charged.
Before fi rst use, charge the battery for at least
3 hours. Li-ion batteries can be charged at
any time without adversely aff ecting their
service life. Interruption of the charging
process will not damage the battery.
Start charging:
♦ Connect the charger to a 230 V ~ 50 Hz
power source.
♦ Connect the charger to the charging socket
on the appliance.
The battery is fully charged when the battery level
display changes from red to green.
Stop charging:
♦ Disconnect the charger from the mains
power supply.
♦ Disconnect the charger from the charging
socket on the appliance.
Changing bits / screwdriver bits
Inserting:
♦ Pull back the locking collar and hold it fi rmly.
♦ Insert the bit into the tool holder and let go
of the locking collar .
Removing:
♦ Pull back the locking collar and hold it fi rmly.
♦ Remove bit and let go of the locking collar .
Operation
Switching the cordless screwdriver
on / off
Switching on:
♦ Press the ON/OFF switch and keep it
pressed in.
Switching off :
♦ Release the ON/OFF switch .
Changing the direction of rotation
Clockwise:
♦ Push the rotation direction switch to the left.
♦ Press the ON/OFF switch . You can now
screw in the screws.
IB_96266_PASS3.6B2_LB2.indb 21 IB_96266_PASS3.6B2_LB2.indb 21 23.12.13 17:04 23.12.13 17:04