Parkside 385568 2107, Operation And Safety Notes Translation Of The Original Instructions

Page: 23 / 157

21 GB/CY
˜
Maintenance
Before any maintenance:
– Switch the product off .
–
Remove the battery pack
[ 15]
.
– Let the product cool down .
Before every use: Check the product for
defects such as loose, worn or damaged
parts .
Apply oil to the safety knife bar
[ 2]
by oil
can or spray (Fig . I and Fig . K) .
Check that the screws in the safety knife
bar
[ 2]
are tight .
Check covers and safety devices for
damages and correct installation . Replace
as necessary .
Use a knife grinder to sharpen and smooth
out minor nudges on the cutting edge of the
safety knife bar
[ 2]
.
Contact a specialist to have a blunt, bent or
damaged safety knife bar
[ 2]
replaced .
m
WARNING! RISK OF INJURY!
u
Do not try to install a safety knife bar
[ 2]
yourself . Installing a knife safety bar shall
only be done by a specialist .
Any maintenance and repair other than
described in this manual: Contact an
authorised service centre or a similarly
qualified person to check or repair the
product . Only use original parts .
˜
Troubleshooting
Problem Possible cause Action
Product does not
start .
Battery pack
[ 15]
is empty . Charge battery pack
[ 15]
(see “Charging the battery
pack”) .
Battery pack
[ 15]
is not properly
inserted .
Insert battery pack
[ 15]
correctly
(see “Removing/inserting the
battery pack”) .
Safety switch
[ 4]
not pressed
properly .
Switch the product on correctly
(see “Switching the product on/
off”) .
Intermittent operation
Internal wiring is defective .
Send the product to Service
Centre for repair .
The on/off switch
[ 7]
is
defective .
Safety knife bar
[ 2]
gets too hot .
Too much friction due to lack of
lubrication .
Oil the safety knife bar
[ 2]
.
The product cuts
poorly .
Too much friction due to lack of
lubrication .
Oil the safety knife bar
[ 2]
.
The safety knife bar
[ 2]
is dirty . Clean the safety knife bar
[ 2]
.
Suboptimal cutting technique . Adjust cutting technique
(see “Working instructions”) .