![background image](http://html1.mh-extra.com/html/parkside/360557-2010/360557-2010_translation-of-the-original-instructions_758354083.webp)
83
MT
GB
Motor unit
with sabre saw
attachment PKGA3
Installing/changing the blade
Secure the appliance against
switching on (see “Switch
-
ing on/off”). If the appliance
is switched on accidentally,
there is a danger of injury.
Wear gloves when handling the
sawblade. In this way, you avoid
injury from cuts.
Caution, risk of Injury!
- Do not use any blunt or bent
blades or blades which are
damaged in any other way.
- Always insert a suitable saw-
blade.
An overview of appropriate blades
can be found in “Spare Parts/Ac-
cessories”.
Installing the blade:
1. Push the lever (18) for sawblade un-
locking downwards as far as the stop
and keep it held down. Push the saw-
blade shaft (19/20) into the sawblade
mounting slot.
2. To unlock, release the lever (18), it will
return to the initial position.
3. Check that the sawblade is secure by
pulling on it.
Removing the sawblade:
4. Press the lever (18) for sawblade un-
locking downwards as far as the stop
and then pull the sawblade out of the
sawblade mounting.
For certain work, the sawblade
can also be inserted after turning
through 180°.
Operating the sabre saw
1. Before switching the appliance on, en-
sure it is not in contact with the work-
piece.
2. Turn the appliance on.
By using the on/off switch (10) you can
progressively control the stroke rate.
Gentle pressure:
low stroke rate.
Greater pressure:
higher stroke rate.
The on/off switch cannot be locked.
3. Place the footplate (17) on the work-
piece.
4. Cut with a uniform forward motion.
5. After completion of the work, first
switch off the device and then remove
the blade from the saw cut.
Sawing
Wear eye protection.
• Use only undamaged sawblades in
perfect condition. Only use metal saw-
blades for metalworking.
• Ensure your stance is stable and hold
the appliance tightly with both hands
and away from your body.
• Before sawing the workpiece, check
for hidden foreign objects such as
nails, screws. These must be removed.
• Plunge cuts may only be made in soft
material such as wood or plaster-
board.
Plunge cuts
Risk of kickback! Hold the
device firmly.
Summary of Contents for 360557 2010
