Parkside 327525 1904, Translation Of The Original Instructions

Page: 12 / 40

12
GB
Installing the grass box
1. Pull the plastic straps over the linkage
tubes.
2. Insert the handle (4a) of the grass
collection box (4) into the provided re-
ceptacle on the upper side of the grass
collection box (4).
Do not operate the appliance
until the collision guard and
grass box are fully installed.
Risk of injury!
Operation
The mower must only be set
when the motor is switched
off and the blades are shut-
down. There is a risk of per-
sonal injury.
Switch of the device, pull the ig-
nition key (12) and wait for the
blades to come to a stop.
Mounting/removing the
grass box
1. To mount the grass catch box (4) lift the
impact protection (5) and mount the
grass catcher box (4).
2. Lower the collision guard (5) onto the
grass box (4) - it will keep it in place.
3. To remove the grass box (4), lift the col-
lision guard (5) and unhook the grass
box from the mounting bracket. Flap
down the collision guard to the hous-
ing (9).
Adjusting the Cut Height
There are 5 different cutting heights:
65 mm - large cutting height
55 mm - medium cutting height
45 mm - medium cutting height
35 mm - low cutting height
25 mm - low cutting height
1. Push the cutting height adjustment lever
(7) away from the unit.
2. Move the lever (7) for adjusting the cut-
ting height past the ratchet mechanism
to the desired cutting height.
The correct height is around 25 – 45 mm
for a decorative lawn and around
45 –65 mm for a used lawn.
A higher cut height should be se-
lected for the fi rst cut of the season.
Observe noise control and local
regulations.
Insert/remove battery
Switch off the device, pull the
ignition key (12) and wait for the
blades to come to a stop. There is a
risk of personal injury.
1. Lift the transparent cover (10) on the
device housing.
2. To insert the battery (11) into the de-
vice, push the battery along the guide
rail into the device. It locks into place
audibly.
3. To remove the battery (11) from the de-
vice, press the release button (11a) on
the battery and pull the battery out.