Parkside 295936, Translation Of The Original Instructions, Page: 15 / 49

PWS 230 C3
GB
│
IE
│
NI
│
CY
│ 11 ■
Fitting the additional handle
CAUTION!
► For safety reasons, this appliance may only
be used with the additional handle .
Failure to do this can lead to serious injury .
The additional handle can be screwed
onto the left or the right depending on the job
at hand .
Fitting/changing the roughing/
cutting disc
Always wear protective gloves when chang-
ing cutting/rough grinding discs.
Roughing and
cutting discs become very hot . Allow them to cool
down completely before touching them .
Pay attention to the dimensions of the roughing/
cutting disc . The diameter of the whole must fit the
mounting flange without any play . Do not use a
reducer or adapter .
■ Check the roughing/cutting disc. It should not
be damaged or damp, and it should have no
cracks.
Otherwise, it could break during use
and cause injuries .
NOTE
► Use only discs which are free of dirt .
■ Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool .
■ RISK OF INJURY! Press the spindle locking
button only when the mounting spindle is
at a complete standstill .
♦ Press the spindle locking button to lock the
motor .
♦ Undo the clamping nut using the two-hole
mounting spanner (see fig D) .
♦ Place the rough grinding or cutting disc with the
label side towards the appliance on the mount-
ing flange .
♦ Then replace the clamping nut with the raised
side facing up on the mounting spindle .
With thin grinding discs (see fig. 1):
♦ The collar of the clamping nut faces upwards
so that a thin grinding disc can be fitted safely .
12
≤ 3,2 mm
> 3,2 mm
Fig . 1
♦ Press the spindle locking button to lock the
motor .
♦ Tighten the clamping nut using the two-hole
mounting spanner .
With thick grinding discs (see fig. 2):
12
≤ 3,2 mm
> 3,2 mm
Fig . 2
The collar of the clamping nut faces upwards so
that the clamping nut can be fitted securely onto
the mounting spindle .
♦ Lock the mounting spindle .
♦ Tighten the clamping nut in a clockwise di-
rection using the two-hole mounting spanner .
NOTE
► If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately .
♦ For safety's sake run the appliance at maximum
speed for 60 seconds after every disc change .
Be aware of unusual noises and sparks .