Parkside 295936, Translation Of The Original Instructions, Page: 13 / 49

PWS 230 C3
GB
│
IE
│
NI
│
CY
│ 9 ■
Working procedures
NOTE
► Grinding tools should only be used for the
recommended applications . Otherwise, they
can break, be damaged or cause injuries .
Rough grinding:
Never use cutting discs for rough
grinding!
■ Move the angle grinder with moderate pres-
sure back and forth over the workpiece.
■
For soft material, move the rough grinding
disc at a shallow angle over the workpiece;
for hard material at a slightly steeper angle.
Abrasive cutting:
Never use rough grinding discs for
cutting!
■ Use only tested fibre-reinforced cutting or
grinding discs
that are approved for a circum-
ferential speed of not less than 80 m/s .
CAUTION!
The grinder continues running after being turned
off . Do not try to brake it by applying lateral
counterpressure .
■ Secure the workpiece! Use clamps/a vice to
hold the workpiece firmly in place . This is much
safer than simply holding it in your hand .
■
Always switch off the appliance before put-
ting it away and wait for the appliance to
come to a complete standstill.
■ Release the ON/OFF switch immediately in
the event of a power failure or when the plug
is pulled out.
Move it into the OFF position . This
prevents an uncontrolled restart .
■ Use the appliance only for dry cutting or
sanding.
■ The additional handle must be mounted on
the appliance for all work.
■ Materials containing asbestos may not be
processed.
Asbestos is a known carcinogen .
Tip! This symbol indicates proper
behaviour.
HAZARD! ALWAYS GUIDE THE
APPLIANCE THROUGH THE WORK-
PIECE IN REVERSE ROTATION .
► In the opposite direction there is a risk of
kickback . The appliance can be pushed out
of the cut .
■ Always switch the appliance on before apply-
ing it to the workpiece.
After completing the
task, lift the appliance from the workpiece and
then switch it off .
■ Always hold the appliance firmly with two
hands while working.
Ensure that your stance
is secure and stable .
■ For an optimum grinding effect, move the ap-
pliance evenly at an angle of 15° to 30° (be-
tween grinding disc and workpiece) backwards
and forwards .