Parkside 273482, Translation Of The Original Instructions

Page: 12 / 40

9 PTSS 1200 A1
GB
IE
Eccentric screws
The eccentric screws are intended for adjusting
the fit of the base plate on the guide rail .
♦ Tighten the eccentric screws to reduce the
play between the circular saw and the guide
rails .
Sawing (without guide rail)
Right-angled sawing
♦ Hold the machine with both hands firmly on the
handles and .
♦ Switch on the appliance as described in
"Switching on and off".
♦ Place the appliance with the front part of the
base plate on the workpiece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Mitre angles up to 45°
♦ Adjust the cutting angle and cutting line as
described.
♦ Hold the machine with both hands firmly on the
handles and .
♦ Switch on the appliance as described in "Switch-
ing on and off". Place the appliance with the front
part of the base plate on the workpiece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Plunge cuts
♦ When making a "plunge cut" which is not at
right angles, secure the base plate of the saw to
prevent any lateral movement. Lateral movement
can cause the saw blade to jam, thus causing
a kickback.
♦ Adjust the desired cutting depth as described
above.
♦ Place the appliance on the workpiece.
♦ Avoid kickback and place the rear edge against
a stop (as referenced in the section "Plunge
cutting with guide rail").
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on the
handles and and pivot it.
NOTE
► The cut width marking on the side of the
blade guard shows the front and rear cutting
point of a 165 mm at maximum cutting
depth. This applies both to plunge cuts with
guide rail and plunge cuts without guide
rail .
Sawing (with guide rail)
Right-angled sawing with guide rail
♦ Place the guide rail with the foam rubber
element on the workpiece.
♦ Place the appliance with the groove onto the
guide rail .
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on the
handles and and pivot it.
Mitre angles up to 45°
♦ Apply the guide rail with the foam rubber
element onto the workpiece.
♦ Place the appliance with the groove onto the
guide rail .
♦ Adjust the cutting angle and cutting line as
described.
♦ Hold the machine with both hands firmly on the
handles and .
♦ Switch on the appliance as described in
"Switching on and off". Place the appliance
with the front part of the base plate on the
workpiece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.