Parkside 273482, Translation Of The Original Instructions

Page: 11 / 40

8 PTSS 1200 A1
GB
IE
Operation
Switching on and off
Switching on:
♦ Push the safety lock-out upwards and hold it
in position.
♦ Press the ON/OFF switch . Once the saw is
running, you can release the safety lock-out .
Switching off:
♦ Release the ON/OFF switch .
Setting the cutting depth (dive depth)
♦ Undo the screw for the cutting depth adjust-
ment and push the stop to the desired
cutting depth on the cutting depth scale :
–
without guide rail, see mark A.
–
with guide rail, see mark B.
♦ Retighten the screw for the cutting depth adjust-
ment .
NOTE
► Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth height
should be visible below the workpiece.
Setting the cutting angle
(mitre angle)
♦ Loosen the two adjustment wheels for the
cutting angle .
♦ Tilt the motor to the desired cutting angle.
♦ Retighten the adjustment wheels .
NOTE
► If you have set the cutting angle adjustment to
0° or 45°, you can use the fine adjustment
screws and
8a
to make any fine adjust-
ment that you require.
Note the cut line
♦ Cut line markings
9a
of 0°/45° are imprinted
into the base plate .
♦ Align the appliance to the corresponding 0°
or 45° cut line markings
9a
in accordance
with the set cutting angle.
♦ The inclined surfaces are reference points for
this.
Connecting the guide rails
The guide rails will help you to make straight
cuts.
♦ To connect the 2 guide rails, push the connec-
tor into the groove of the guide rails. Tighten
the grub screws using the Hex key supplied.
NOTE
► The guide rails have a splinter guard
(black rubber lip). The splinter guard must be
adjusted before making the first cut. Place the
guide rail onto a workpiece. Set a cutting
depth of approx. 10 mm. Switch the circular
saw on and push it gently and evenly in the
cutting direction.
9a