Once the controller is secured, it is time to route the control cable from
the controller to the APU.
●
Connect the square end into the controller.
●
Using the Adel clamps, secure the cable to the wall.
●
Route the cable out of sight, if possible.
●
Track the cable back to the evaporator box.
●
Push the round APU-end of the controller through the
floor collar.
●
From the outside of the truck, pull enough slack to reach
the APU.
●
Cable-tie the control cable up and out of the way, being
sure to leave enough length to reach the APU without
leaving too much additional slack.
●
Connect the power supply to the evaporator as shown in
the figure to the right.
31 |
Page
Summary of Contents for HP2000 XTREME Series
