Parkinson Cowan Lyric 50 GX, Owner'S Handbook Manual

Page: 48 / 60

LOCATION OF APPLIANCE
This appliance must not be installed in a bed-sitting room of volume less than 20m³ or in a bathroom or
shower room. It is essential that the appliance is positioned as stated below. The appliance must be a
minimum of 20mm from the rear wall (note that this dimension is provided by the inlet elbow). Shelves, wall
cabinets and cooker hoods must not be fitted closer that 500mm to the top of the grill canopy or within
100mm of the sides of the grill. Curtains must not be fitted immediately behind the appliance or within
200mm of the sides of the grill. If fitted next to or between two base units a minimum space of 1mm must
be left between the units and the sides of the appliance. The hotplate must be set to a minimum of 7mm
above the adjacent units (note that the levelling feet fitted to the appliance will achieve a nominal height to
hotplate level of 907mm -5+13mm). Base units not meeting the above conditions must be a minimum of
100mm away from the hotplate. L.P.G. cookers MUST NOT be installed below ground level, i.e. in a
basement.
INSTALLATION
1. PARTS REQUIRED
The loose hotplate parts are packed in the polystyrene fitment on the
top of the hotplate. The grill pan, grill pan handle, fixing screws and
splashplate fixing screws can be found in the oven pack which is
located in the oven compartment. The grill pan requires assembly
before use (see Fig. 1).
2. GRILL ASSEMBLY
The two splashplate screws should be screwed into the back of the
appliance about halfway in (see Fig. 1a.) Engage the keyhole slots in
the splashback behind the two screws taking care not to trap the H.T.
wire (see Fig. 1b).
Tighten 6 off splashplate screws (see Fig.1c).
Connect the grill supply union at the back of the appliance and pull the
grill H.T. lead through the opening in the splashplate and connect on
to the spark generator.
4
Fig.1c
Fig.1a
Grill Pan Handle Assembly:-
Assemble grill pan (see Fig.1)
and secure four screws and
washers provided.
Fig.1
Fig.1b