Parker DAS 1, User Manual, Page: 5 / 265

Safety Information EN
4
2.1.1 Dimensions
Refer to diagram A1 in Annex A for dimensions and weights
Minimum Operating Pressure
4 bar g
58 psi g
Maximum Operating Pressure
12 bar g
175 psi g
Minimum Operating Temperature
2
o
C
35
o
F
Maximum Inlet Air Temperature
50
o
C
122
o
F
Maximum Ambient Air Temperature
55
o
C
131
o
F
Noise Level <70 dB(A)
Standard Electrical Supply 230 V 1ph 50 Hz 60Hz
Optional Electrical Supply 110 V 1ph 50 Hz 60Hz
Dewpoint
-40
o
C
-40
o
F
Optional Dewpoint
-70
o
C
-70
o
F
ISO 8573.1 : 2001 Classification Class 2 Water
Standard Thread Connections BSPP
Optional Thread Connections NPT
Approvals
CRN OH0182.9C
CSA 173682 (LR56310
Before continuing with the installation and commissioning of this equipment:
Ensure that it is correctly sized for the inlet pressure, taking into consideration the pressure drop caused by the valves, pipes and filters within
the system. Allowance should be made for purge air loss. The dryer should be typically sized at 1 bar (14 psi/0.1MPa) below nominal
compressor output pressure.
The purge air flow is factory set for 6 bar g (87 psi g) minimum system pressure. Should the minimum supply pressure be higher or lower than
this figure the purge air flow must be reset in order to maintain the specified dewpoint. Please contact your local Parker domnick hunter office
for assistance.
Ensure that it is correctly sized for inlet temperature to meet the dewpoint specified.
-40°C (-40°F)
Ensure that the electrical supply voltage and frequency meet the requirements detailed within this specification and on the equipment rating
plate.