Parker Compumotor 6000 Series, Installation Manual

Page: 12 / 59

Chapter 1. Installation 5
PC Card Installation
CAUTION
While handling the AT6n50 card, be sure to observe proper grounding techniques to
prevent electro-static discharge (ESD).
1 . Turn off the power to the computer.
2 . Remove the computerÕs cover to access the internal slots
where peripheral cards are added.
3 . Select an expansion slot in your PC and remove the sheet
metal bracket that covers the associated external access
slot.
Save the screw. On IBM-compatible computers, this
is at the rear access panel where all external connections are
made. This bracket is replaced by the bracket on the end of
the AT6n50 card.
4 . Select a 16-bit slot to install the AT6n50 card.
5 . Insert the bottom corner of the AT6n50 PC card into the
card guide slot near the front of the computer. Ease both
ends of the card simultaneously down into the computer
until the cardÕs edge connector reaches the computerÕs
mating connector (see drawing below). Adjust the card
until the edge connectors align and press it down into the
mating connector.
6 . Using the screw that secured the original access slot
cover bracket, fasten the AT6n50 mounting bracket to
the computer chassis (see drawing below).
Computer
Chassis
AT6n50
PC Card
PCA Card
Guide
Edge
Connector
Mounting
Screw
Mounting
Bracket
ANI Card Installation
If you ordered the ANI analog input card
(p/n OPT-AT6N50-A) with your AT6n50
system, install it now.
AT6n50 Card
Computer
Chassis
ANI Card
Ribbon Cable :
Use the ribbon cable to connect the
ANI card to the AT6n50 card. On the
AT6n50 card, be sure to
use the J2
connector, NOT the J3 connector.
Power LED
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com