Notes on the Documents Supplied
High power devices
4
192-120149 N08 June 2014
1.1
C3 ServoManager
The Compax3 ServoManager can be installed directly from the Compax3 DVD.
Click on the corresponding hyperlink resp. start the installation program
"C3Mgr_Setup_V.....exe" and follow the instructions.
PC requirements
Recommendation:
Operating system:
MS Windows XP SP3 / MS Vista (32 Bit) / Windows 7 (32 Bit / 64 Bit)
Browser:
MS Internet Explorer 8.x or higher
Processor:
Intel / AMD Multi core processor >=2GHz
RAM memory:
>= 1024MB
Hard disk:
>= 20GB available memory
Drive:
DVD drive (for installation)
Monitor:
Resolution 1024x768 or higher
Graphics card:
on onboard graphics (for performance reasons)
Interface:
USB 2.0
Minimum requirements:
Operating system:
MS Windows XP SP2 / MS Windows 2000 as from SP4
Browser:
MS Internet Explorer 6.x
Processor:
>=1.5GHz
RAM memory:
512MB
Hard disk:
10GB available memory
Drive:
DVD drive
Monitor:
Resolution 1024x768 or higher
Graphics card:
on onboard graphics (for performance reasons)
Interface:
USB
For the installation of the software you need administrator authorization on the
target computer.
Note:
Several applications running in parallel, reduce the performance and operability.
Especially customer applications, exchanging standard system components
(drivers) in order to improve their own performance, may have a strong influence
on the communication performance or even render normal use impossible.
Operation under virtual machines such as Vware Workstation 6/ MS Virtual PC is
not possible.
Onboard graphics card solutions reduce the system performance by up to 20% and
cannot be recommended.
Operation with notebooks in current-saving mode may lead, in individual cases, to
communication problems.
Your PC is connected with Compax3 via a RS232 cable (SSK1) and an adapter
cable.
Cable SSK1 (COM 1/2-interface on the PC to X10 on the Compax3 or via adapter
SSK32/20 on programming interface of Compax3H)*.
Start the Compax3 ServoManager and make the setting for the selected interface in
the "
Options Communication settings RS232/RS485..."
menu.
* please make sure that a suitable strain relief is used at the telephone socket of the programming port if a
SSK1 >2m is utilized.
In the menu tree under device selection you can read the device type of the
connected device (Online Device Identification) or select a device type (Device
Selection Wizard).
Then you can double click on "Configuration" to start the configuration wizard. The
wizard will lead you through all input windows of the configuration.
Installation of the
C3 ServoManager
Connection between
PC and Compax3
Device Selection
Configuration
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - [email protected]
